Acceptable OMC Cobra 86 prop shaft run-out??? - prop shaft repairs
I have read leads .003 "max-out. But where to measure? Know that my drive shaft was bent - but if you measure 1" pushed over the side, the propeller - in 0015 - As the end of + .150. This vibration at low speeds, but smoothed out by air. I know what needs attention, but there is only one months of navigation. Can I expect that (during the winter months, maybe 5 more Fishing on Saturday to repair), or requires immediate attention. Or is it normal to worry about at all? No evidence of wear of the gasket (water in oil).
Monday, December 21, 2009
Prop Shaft Repairs Acceptable OMC Cobra 86 Prop Shaft Run-out???
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment